TM 5-2420-230-24-1
10-31. HOSE REEL SPRING MOTOR REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
Cap and plug set, Item 4, Appendix C
"Do Not Operate" tag attached
Loctite 567, Item 22, Appendix C
to ignition switch.
Nut, self-locking, Item 117.1, Appendix D (2)
Hose reel stowed (cover
Tags, identification, Item 63, Appendix C
removed).
Personnel Required
Drawings Required
MOS 62B, Construction Equipment Repairer
TM 5-2420-230-24P Figure 184
TM 5-2420-230-24P Figure 185
References
None
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
The spring motor is under tension when installed. To prevent injury, relieve tension before removing
spring motor. Failure to comply may result in injury or death to personnel.
NOTE
Perform Steps (1) through (3) to release tension on spring motor.
(1)
Remove two nuts (1), screws (2), and hose stop (3) from hoses (4).
(2)
Wind hose assembly (4) through roller assembly (5) onto hose reel (6).
10-77
Change 1