TM 5-2420-230-24-1
c. Follow-On Maintenance.
(1)
Close engine hood and secure clips (TM 5-2420-230-10).
(2)
Start engine and check for leaks (TM 5-2420-230-10).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
20-18. BATTERY TRICKLE CHARGER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Tools and Special Tools
Equipment Conditions
Tool kit, common no. 2, Item 36, Appendix B
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
Battery box opened.
Electrical outlet unplugged.
Materials/Parts
Hydraulic reservoir step plate
Connector, wire, Item 39.2, Appendix D (3)
removed.
Tags, identification, Item 63, Appendix C
Tape, electrical, Item 65, Appendix C
Drawings Required
Ties, cable, Item 68, Appendix C
TM 5-2420-230-24P Figure 207
Washer, lock, Item 268.1, Appendix D (4)
Estimated Time to Complete Task
Refer to MAC in Appendix B
Personnel Required
MOS 62B, Construction Equipment Repairer
a. Removal.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Tag all wires and note their positions before
removal.
Remove negative (-) cable before removing
positive (+) cable.
Remove cable ties as necessary.
(1)
Loosen nut (1) and remove negative (-) terminal (2) from negative (-) terminal post (3).
(2)
Remove nut (4), screw (5), and wire (6) from negative (-) terminal (2).
Change 1
